Table of Contents
Advertisement
174
Airbag
system
There are some important things you have to
know to make sure that the effectiveness of
the system will not be impaired and that dis-
carded components do not cause injury or pol -
lute the environment.
A
WARNING
Improper care, servicing and repair proce-
dures can increase the risk of personal in-
jury and death by preventing an airbag
from deploying when needed or deploying
an airbag unexpectedly:
- Never cover, obstruct, or change the
steering wheel horn pad or airbag cover
or the instrument panel or modify them
in any way.
- Never attach any objects such as cu-
pholders or telephone mountings to the
surfaces covering the airbag units.
- For cleaning the horn pad or instrument
panel, use only a soft, dry cloth or one
moistened with plain water. Solvents or
cleaners could damage the airbag cover
or change the stiffness or strength of the
material so that the airbag cannot de-
ploy and protect properly.
- Never repair, adjust, or change any parts
of the airbag system .
- All work on the steering wheel, instru-
ment panel, front seats or electrical sys-
tem (including the installation of audio
equipment, cellular telephones and CB
radios, etc .) must be performed by a
qualified technician who has the training
and special equipment necessary.
- For any work on the airbag system, we
strongly recommend that you see your
authorized Audi dealer or qualified work-
shop.
- Never modify the front bumper or parts
of the vehicle body.
- Always make sure that the side airbag
can inflate without interference:
- Never install seat covers or replace-
ment upholstery over the front seat-
backs that have not been specifically
approved by Audi .
- Never use additional seat cushions that
cover the areas where the side airbags
inflate.
- Damage to the original seat covers or
to the seam in the area of the side air-
bag module must always be repaired
immediately by an authorized Audi
dealer .
- The airbag system can be activated only
once. After an airbag has inflated, it
must be replaced by an authorized Audi
dealer or qualified technician who has
the technical information, training and
special equipment necessary.
- The airbag system can be deployed only
once . After an airbag has been deployed,
it must be replaced with new replace-
ment parts designed and approved espe-
cially for your Audi model version. Re-
placement of complete airbag systems
or airbag components must be per-
formed by qualified workshops only.
Make sure that any airbag service action
is entered in your Audi Warranty & Main-
tenance booklet under AIRBAG REPLACE-
MENT RECORD.
- In accidents when an airbag is deployed,
the vehicle battery separates the alterna-
tor and the starter from the vehicle elec-
trical system for safety reasons with a
pyrotechnic circuit interrupter.
- Work on the pyrotechnic circuit inter-
rupter must only be performed by a
qualified dealer - risk of an accident!
- If the vehicle or the circuit interrupter
is scrapped, all applicable safety pre -
cautions must be followed.
@
For the sake of the environment
Undeployed airbag modules and preten-
sioners might be classified as Perchlorate
Material -special handling may apply, see
www.dtsc.ca.gov/hazardouswaste/per-
chlorate. When the vehicle or parts of the
restraint system including airbag modules
safety belts with pretensioners are scrap-
ped, all applicable laws and regulations
must be observed. Your authorized Audi
1J1-
Advertisement
Table of Contents
