NordicTrack COMMERCIAL X22i User Manual page 29

SYMPTOM: The walking belt does not move
If the console displays time and distance while a
workout is running, but the walking belt does not move,
follow the steps below.
a. Turn off the power (see page 15) and unplug the
power cord.
b. Wait for a minimum of five minutes to make sure
that any residual charge has dissipated from the
incline trainer's electronics.
c. Plug in the power cord (see page 13), turn on the
power, and start the walking belt again.
d. If the walking belt still does not run, please see
TROUBLESHOOTING on page 28 for further
assistance.
SYMPTOM: The incline trainer will not connect to
the wireless network
a. Make sure that the wireless settings on the console
are correct (see page 24).
b. Make sure that the settings for your wireless net-
work are correct.
c. If you still have questions, go to my.iFIT.com.
SYMPTOM: The console does not stay in place
a. If the console will not stay in the desired position
because it is too loose, use a hex key to slightly
tighten the console in the indicated location on both
sides (only one side is shown).
a
SYMPTOM: The displays of the console do not
function properly
a. If the console does not boot up properly, or
if the console freezes and does not respond,
reset the console to the factory default settings.
IMPORTANT: Doing this will erase all of the
custom settings that you have made to the
console. Resetting the console requires two
people. First, press the power switch into the off
position. Next, locate the indicated small opening
(C) on the side of the console. Using a bent paper
clip (D), press and hold the small button inside of
the opening and have a second person press the
power switch into the on/reset position. Continue
to hold the button inside of the opening until the
console turns on. When the reset operation is
complete, the console will turn off and then turn
back on. If it does not, use the power switch to
turn the incline trainer off and then on again. Once
the console turns on, check for firmware updates
(see step 6 on page 23). Note: It may take a few
minutes for the console to be ready for use.
a
29
D
C