Operatingexternalcomponents W Iththe Remotecontrol; Operatingthe Tv - JVC TH-S3 Instructions Manual

Operatingexternalcomponents w iththe remotecontrol
The buttons described below are used on pages 11 and
12.
TV/V|DEO ,_
TV VOL +/- ,2
CHANNEL +/- -
<1<1--
II-
REC -
TV RETURN
TV VCR
O0
0
© ©
©©
TVVOL CHANNEL /_%
Q
0/t VCR
©/t TV
Remote control
mode selector
ENTER
Number
buttons
100+
NOTE
• Mmmlactmers' codes are subject to change without notice.
• Set the codes again after replacing the batteries ofthe remote control.
4
Press number buttons (1-9, O) to enter
the manufacturer's code (2 digits).
Examples:
For a Hitachi TV:
Press 1, then 0.
For a Toshiba TV:
Press 0, then 8.
Manufacturer Code Manufacturer
JVC 01 Samsung
Hitachi 10 Sanyo
Magnavox 02 Sharp
Mitsubishi 03 Sony
Panasonic 04, 11 Toshiba
RCA 05 Zenith
Code
12
13
O6
O7
O8
O9
Release cb/ITV.
If there is more than one code listed for corresponding brand,
try each one until you enter the correct one.
• Operation
Aim the remote control at the TV.
IMPORTANT
Before using the remote control to operate a TV;
• Set the remote control mode selector to TV.
The following buttons are available:
(b/I TV:Turns TV on and off.
TV VOL +/-:Ac[iusts the volume.
TVNIDEO:Selects the input mode (either TV or VIDEO).
CHANNEL +/-:Changes the channels.
1-10, 0, +10 (100+):Selects the channel.
TV RETURN:Alternates between the previously selected channel
and the current channel.
• To set the manufacturer's code
You can operate :t JVC TV without setting the manufacturer's code.
1 Slide the remote control mode selector
to TV.
2 Press and hold cb/ITV.
Keep the button pressed until step 4 is finished.
3
Press ENTER.
11