Advertisement
INST ALLA TION OF VOICE MODULE
The Voice Module provides not only remote audio but voice
announcements as well.
To install:
• Make sure the external speaker option is turned on (factory)
default setting is voice on, if not see option mode in owners
manual
• For maximum volume, find a convenient location close to
the driver's ear, such as the trim panel between A & B pillars.
Attach speaker using the supplied clip or velcro.
• Plug the cable into the aux cable on the detector. Run this
cable conveniently from the detector to the location selected,
so that it doesn't interfere with normal driving operation.
NOTE: This module has its own independent volume control.
17
TROUBLESHOOTING
PROBLEM: No display or audio.
• Check fuse in power cable, replace if necessary.
• Check fuse in fuse box, replace if necessary.
• Make sure power cable is properly grounded.
PROBLEM: Unit alarms when using vehicle equipment or
electrical accessories (brakes, power mirrors/windows,
directionals, horn, etc.)
• Check condition of vehicle's electrical system, including
battery and alternator.
• Install a filter capacitor (470mfd. 25 volt or larger
capacitor value) where power connection is made.
PROBLEM: Audio alerts are not loud enough.
• Cancel Auto Quiet Mode or City Mode
• Check audio level settings.
PROBLEM: Display shows R error.
• Warning communicates "loss of link" between
control panel and front antenna (RADAR).
• Check antenna connection at back of control panel.
• Contact factory, if you suspect antenna is defective.
• Look for cuts in the cable
If difficulties occur which cannot be solved by information in this
Troubleshooting Guide, please call Whistler Customer Service at
1-800-531-0004 or visit our FAQ page at www.whistlergroup.com,
before returning your unit for service.
For warranty information, refer to owner's manual.
18
Advertisement
