Advertisement
FRONT PANEL FACILITIES
1) POWER
STANDBY/ON
Switch
To switch the unit between ON/STANDBY. When the power
is turned ON, the volume indicator will flash for about 6 seconds.
Press the switch again to set the unit to standby mode.
{Timer ON/OFF possible]
When
the unit is switched
ON, ON/OFF
control can
be
performed by means of the optional timer.
NOTE:
When the power is turned ON, muting will be applied to
prevent sound from being output while the volume level
indicator is flashing (about 6 seconds)
@ SPEAKERS ON/OFF Switches
A:
Press to listen through the speakers connected
to the A
terminals.
B:
Press to listen through the speakers connected
to the B
terminals. Surround output is sent to the SPEAKERS B terminals
when the rear panel SURROUND
switch is ON.
© REMOTE SENSOR Window
© Video INPUT SELECTOR Switches
VCR 1:
Press this switch when playing back a tape in the video deck
connected to the VCR 1 terminals.
VCR 2:
Press this switch when playing back a tape in the video deck
connected to the VCR 2 terminals.
VDP/CDV:
Press to watch a program from a video disc player or a video
compact disc player connected to the VDP/CDV terminals.
TV:
Press to watch
TV programs
(reception with a TV tuner
connected to the TV terminals).
5] VIDEO SIGNAL
SELECTOR
The monitor output (TO MONITOR TV) and VCR REC output
changes in the order of
[7 VCR 1>VOR 2-=VDPCDV = TV
oncaeid
each time the switch is pressed.
(The sound output is not affected.)
NOTE:.
When using a VCR for sound recording only, follow the
operating instructions of the VCR.
@
Audio INPUT SELECTOR
Switches
DAT/TAPE 1:
Press to listen to the sound from the component connected to
the DAT/TAPE 1 terminals.
TAPE 2:
Press to listen to the playback sound from the tape deck
connected to the TAPE 2 terminais.
cD:
Press to listen to the playback sound from the CD player
connected to the CD terminals.
TUNER:
Press to listen to AM or FM broadcasts with the tuner connected
to the TUNER terminals.
PHONO:
Press to listen to the playback sound from the record player
connected to the PHONO terminals.
NOTE:
The DAT/TAPE 1 signal can be monitored at the TAPE 2
REC terminals, allowing for DAT/TAPE 1. TAPE 2 dubbing.
@ SURROUND Mode Selector Switches
This switch operates when the SURROUND switch on the rear
panel is set to ON.
OFF:
To cancel the surround function.
STADIUM:
\deal for sports broadcasts, etc.
SIMULATED SURROUND:
Gives concert-hall presence to monaural sound (AM, TV, etc.).
DOLBY SURROUND:
Select this setting when watching video tapes or video disk
player bearing the D0 DOLBY STEREO or
OO DOLBY
SURROUND
mark.
@ MASTER VOLUME Control
Adjusts sound volume level. To adjust the balance between front
and rear speakers volume for surround playback, also use the
SURROUND VOLUME.
© MUTING Switch
Used to temporarily mute the sound. The volume is restored
-when pressed again.
@ TREBLE Switches
Use to adjust the high-frequency level. Press the + switch to
increase high-frequency level, and the - switch to decrease it.
@ BASS Switches
Use to adjust the low-frequency level. Press the + switch to
increase low-frequency level, and the - switch to decrease it.
7
<ARE1065>
Advertisement
