Advertisement
CONNECTIONS
CONNECTING
SPEAKER WIRES
Example:
For the lower-row speaker terminals.
1.
Strip off the vinyl covering and twist the strands together.
10 ow
2.
Raise the lever in the direction of the arrow and insert the
exposed conductor into the hole.
3.
Return the lever to its original position to secure the cord.
®
L ®
NOTE:
¢
Do not allow any of the cord's conductors to protrude
from the terminals or touch any other conductors.
¢
Malfunctioning
.or breakdowns
may
occur
when
conductors come into contact with each other.
REMOTE CONTROL CORD CONNECTIONS
The connections shown below are performed when using the
VSA-700 remote sensor.
¢
By interconnecting the CONTROL jacks of Pioneer units with
the
mark, the entire system can be operated with this
remote control unit, although some of the units (AM/FM
tuner, turntable, cassette deck, etc.) may not be equipped
with remote sensors. The entire system can be operated by
a remote
control
unit
connecting
PIONEER
stereo
components
to each
other
using
the
control
input
(CONTROL IN) jack on each component. Use the remote
control cord supplied
with the respective unit for the
connection. An example is shown in the drawing below. As
long as you connect
'"'OUT"" to "IN", the connecting
sequence is arbitrary. In the case of a unit which has only
an "IN" connector, however, connect it last.
CONNECTING
INPUT/OUTPUT CORDS
Connect white plugs to the L (left) side, and red plugs to the
R (right) side. Be sure to push the plugs in securely.
Left channel
ow
Right channel —@
—
Gye
Red plug
White plug
Component display
VSA-700
Remote control unit
15
<ARE1065 >
Advertisement
