Advertisement
TROUBLESHOOTING
incorrect operations are often mistaken for trouble and malfunctions. If you think that there is something wrong with this component,
check the points below. Sometimes the trouble may lie in another component. Investigate the other components and electrical appliances
being used,
If the trouble connot be rectified even after exercising the checks listed below, ask your nearest PIONEER authorized service center
or your dealer to carry out repair work.
Symptoms
Posibble Causes
Remedy
Power does not come on
e Power plug has been removed from the outlet.
* The power plug has been connected to the outlet
of another component (such as timer), and the
power of the other unit is off.
There is no sound
(When playing tape)
(Other situations)
There is no picture
MUTING (— ©) switch is set to ON.
dirty.
e
dirty.
e
for playback.
The video adaptor switch is ON.
¢ insert into the wall or timer outlet.
« Turn on the power of the other component.
The connection cords have come
off from the
terminals or are improperly connected.
The pin plugs ef connection cords or terminals are
The speaker ON/OFF switch is set to OFF.
DAT/TAPE
1 or TAPE 2 is set to ON.
DATITAPE 1, TAPE 2 switch set to OFF.
Operation of the tape deck is incorrect.
The connection cords have come
off from the
terminals or are improperly connected.
The pin plugs of connection cords or terminals are
The position of the input selector switch or video
selector does not match the component selected
Operation of the other component is incorrect.
¢ Connect properly.
¢ Remove the dirt.
* Set the switch to ON (A or B).
© Set the switch to OFF.
e Refer
to the
Owner's
Manual
component.
* Connect properly.
« Remove the dirt.
¢ Set the switch to the proper position.
¢ Set the switch to OFF.
® Refer
to the
Owner's
Manual
component.
¢ Set the MUTING (— &) switch to OFF.
* Set to ON (DAT/TAPE 1 or TAPE 2).
* Refer to the Owner's Manual of the tape deck.
The position of the input selector switch does not
match the component selected for playback.
Operation of the other component is incorrect.
* Set the switch to the proper position.
of the
other
of the
other
There is sound from only one
speaker
connected.
One of the connector cords or speaker cords is not
BALANCE control not set to center position.
¢ Connect properly.
¢ Press both buttons to reset to center position.
:
Recording on tape is not
possible
* Operation of the tape deck is incorrect.
¢ Refer to the Owner's Manual of the tape deck.
Tape dubbing is not possible
© Operation of the tape deck is incorrect.
¢ Refer to the Owner's Manual of the tape deck.
No surround effect
¢ SPEAKERS B switch is set to OFF.
¢ SURROUND
switch is set to OFF.
¢ Set SPEAKERS B switch to ON.
* Set SURROUND
switch to ON (rear panel).
¢ Audio input is monaural.
* Set to SIMULATED SURROUND
mode.
29
<ARE1065 >
Advertisement
