Advertisement
REMOTE CONTROL OPERATIONS
LOADING
BATTERIES
INTO
THE
REMOTE
CONTROL UNIT
1.
Open the battery compartment cover on the rear of
the remote control unit. The cover should open easily
if you slide it in the direction of the arrow while
pressing on it with your thumb.
2.
Take
out
the
four
supplied
alkali
(LRO3/AM-4)
batteries,
and
insert
them
into
the
battery
compartment in accordance with the indications in
the compartment.
3.
Close the cover of the battery compartment.
Cover
Reset button
Incorrect use of batteries may lead to leakage
or rupture. Always be sure to follow these
guidelines:
A.
Always insert batteries into the battery compartment correctly
matching the positive (+) and negative (—) polarities, as
indicated inside the compartment.
B.
Never mix new and used batteries.
Cc.
Batteries
of the same
size may
have
different voltages,
depending on their type. Do not mix different type of batteries.
D.
Both
rechargeable
and
non-rechargeable
batteries
are
available. Be sure to use your batteries in accordance with the
caution labels affixed to them.
16
<ARE1065>
OPERATION
RANGE
OF REMOTE
CONTROL
UNIT
When operating the remote control unit, point the infrared signal
transmitter part of the unit at the remote control receiver
(REMOTE SENSOR) on the front panel of the VSA-700. The
remote control unit may be used within a range of about 7
meters (23 feet) from the remote sensor, within angles of up
to about 30 degrees.
(_
aot
LA
7 m (23 feet)
Battery Replacement
When the battery is terminated, the transmit indicator will not
light up even when a key is pressed. Be sure to replace the
batteries as soon as possible. As the programmed functions
will be retained in memory only as long as batteries are inserted,
remove the old batteries only if they can be replaced by new
ones immediately.
Also, be sure to use always the specified batteries (LRO3/AM-4
alkaline batteries).
NOTE:
When no batteries are inserted, the programmed memory
contents will be erased after 30 to 60 minutes.
Advertisement
