Unpacking And Positioning; Pre-Installation Requirements - yuna CALOR EBK4-2B G Instruction Manual

CAUTION!
Do not install the appliance above cooling equipment, dish washers or laundry dryers.
CAUTION!
When installing the appliance ensure optimal heat radiation to maintain the operating
CAUTION!
The wall and the reach of the heat radiation above the worktop must be made of heat-
CAUTION!
To avoid any damage, the sandwich layer and adhesive must resist heat.
1. Unpack the appliance carefully. Dispose of the packaging as described in chapter
.
WASTE MANAGEMENT
2. The appliance may be equipped with the transport-protection. Be very careful and
do not use any aggressive or abrasive detergents to remove residuals of the transport-
protection.
3. Check that the appliance and the power cord are not damaged.
4. Connect the appliance to a dedicated socket only.
5. Do not install the appliance in a place where it may come in contact with water or
rain; otherwise the insulation of the electrical system will be damaged.
6. Connect the appliance to the mains properly.
The worktop must be rectangular and plane and made of heat-resisting material.
Structural elements should not interfere with the installation area.
The installation must meet the safety requirements as well as the legal rules and regu-
lations.
The wall sat the hob should be covered with heat-resistant material, e.g. ceramic tiles.
safety.
resistant materials.

2.1 Unpacking and positioning

2.2 Pre-installation requirements

8