yuna CALOR EBK4-2B G Instruction Manual page 30

Your cookware is produced with lay-
ers made of different kinds of metal.
C
AUSES
T
HE APPLIANCE MAKES HUMMING NOISE WHEN USED ON A HIGH HEAT
Caused by induction-cooking.
N
OISE CAUSED BY THE FAN INSIDE THE APPLIANCE
The cooling-fan the appliance is
equipped with protects the electron-
ics from being overheated. It may
continue to run even after you have
switched the appliance off.
C
OOKWARE DOES NOT BECOME HOT AND THE RELEVANT SYMBOL IS
Cookware cannot be detected, be-
cause it is unsuitable, too small or im-
properly positioned on the cooking
zone.
T
HE APPLIANCE OR A COOKING ZONE HAS BEEN SWITCHED OFF
AUTOMATICALLY AND UNEXPECTEDLY
AND AN ERROR CODE IS DISPLAYED
ONE OR TWO DIGITS ON THE TIMER
Technical malfunction.
If the appliance shows a malfunction not noted on the schedule above or if you have
checked all items on the above schedule but the problem still exists, please contact
the customer service.
Depending on model
5
Depending on model
6
This is normal for such a cookware
and does not indicate a
E
RROR
M
.
SETTING
Normal operating condition, but the
noise should decrease or disappear
after decreasing the heat setting.
Normal operating condition. Do not
disconnect the appliance from the
mains while the fan is running.
.
DISPLAYED
Use suitable cookware which meets
the diameter of the cooking zone.
Place cookware on the centre of the
,
AN ACOUSTIC SIGNAL SOUNDS
(
5
TYPICALLY ALTERNATING WITH
-
DISPLAY
Note the complete error-code
disconnect the appliance from the
mains and contact the customer
malfunction.
EASURES
.
cooking zone.
).
6
service.
,
29