Dimplex Optimyst CAS500R-RGB-EU Operating Instructions Manual page 8

FLAME INTENSITY: You can adjust the flame intensity by selecting
to choose from, press
manual controls press the
time to react to the changes you make.
TIP: Lower levels give a gentle slow flame, higher levels a faster fuller flame.
FLAME BRIGHTNESS: During spring and summer when the days or longer you may need to increase the brightness
of the flame to make it more vivid. Select the brightness icon
brightness options 1 to 6 and ENTER to select.
TIP: depending on the lighting, surrounding décor colours and airflow in the room, making adjustments the flame
intensity, colour and brightness can make a real difference to you look and feel of this fireplace.
SOUND: For authenticity you can add the sound of crackling logs to the flame effect. Select the
to adjust the sound level by pressing
the sound on/off.
Once you have made your adjustments to both the flame height and crackling sound, the appliance will keep these set-
tings even if you power off the appliance by either the on/standby button or by the main switch. The next time you switch
on the appliance, it will start up as normal, wait 45 seconds for the flames to start and then revert to the adjusted
MANUAL & REMOTE CONTROL OPTIONS
Standby
Increase Flame
Decrease Flame
Flame Theme
Volume and
crackle sound
(Manual controls)
Increase Volume
(Remote)
Decrease Volume
(Remote)
Brightness
Timer
Bluetooth
or to adjust intensity, F1 being the lowest setting and F6 being the highest setting. On the
and buttons to adjust the flame to your desired level. Please give the flame generator
or followed by ENTER to select. On the manual controls the
Press to turn on the unit or to put it into standby mode. There is a brief delay after
pressing this button before the unit turns on.
Note: When the unit is turned on there is a 45 second warm up sequence before
the flame effect starts.
Press repeatedly (or press and hold) to increase flame intensity.
The unit will emit an audible beep when max level reached.
Press repeatedly (or press and hold) to decrease flame intensity.
The unit will emit an audible beep when min level reached.
Press repeatedly to cycle through the different Flame themes below:
1 - Natural Flame
2 - Blue
3 - Violet
4 - Red
5 - Aquamarine
6 - Prism Mode - the flames will cycle through the different colours.
Press repeatedly to cycle through volume levels from OFF to level 6.
Press repeatedly (or press and hold) to increase the volume level of the crackling
sound effect.
Press repeatedly (or press and hold) to decrease the volume level of the crackling
sound effect.
Press repeatedly to cycle the Flame brightness settings:
B1 - Brightness level 1
B2 - Brightness level 2
B3 - Brightness level 3
B4 - Brightness level 4
B5 - Brightness level 5
B6 - Pulsating effect
Press repeatedly to set the duration of the timer. The fireplace goes into standby
after the time has elapsed.
The timer can be set for 1 hour (1 presses), 2 hour (2 presses) and Timer OFF (3
presses).
Press this button for pairing remote handset - refer to 'PAIRING THE REMOTE
CONTROL'.
and press ENTER to adjust. There are 6 levels
on the romote and press enter. Use
8
or to adjust
icon on the remote
button turns
settings.