Table of Contents
Advertisement
■Banner Print Extension Kit
Long paper can be loaded without its lead edge sticking out.
Paper size (mm)
Width: 210 to 330.2
Length: 488.1 to 1,200
Important
When paper exceeding the tray capacity is loaded, the Extension Tray may get broken.
■Extension Tray
(1)
Push the Top Output Tray from the rear side as pinching
the cap and remove the 4 caps at the front edge of the Top
Output Tray.
(2)
Change the angle of the Top Output Tray to the upper
fixed position (B).
Note
Change the angle to the lower fixed position (A) for paper with the
width of 256 mm or less.
(3)
Insert 2 extension trays until they stop.
Note
Pass them through over the guide at the rear side of the tray until
they stop.
￭ Lightweight paper housing wire
When it is difficult to load thin paper, install the wire.
Note
• The tray capacity is 10 sheets.
• Paper of which width is 256 mm or less cannot be used.
• The supported paper weights are from 82 to 209 g/m
Tray capacity (sheets)
Up to 660 mm: 150
Up to 729 mm: 100
More than 729.1 mm: 10
Note
This value applies if 82 g/m2 paper is used.
.
2
71
Finisher
Advertisement
Chapters
Table of Contents
