Installation - Denon DRA-625R Operating Instructions Manual

ENGLISH
ANTENNA INSTALLATION
e FM ANTENNA
The T-type indoor antenna (300 ohm) can be used inside wooden houses for local FM stations and strong signals.
Orient the T-shaped part for optimum reception and mount the antenna on the wall or ceiling. (FM indoor antennas may not
consistently ensure stable reception, due to environment changes. In such cases use an FM indoor antenna temporarily until an
outdoor antenna is installed.)
75 ohms coaxial cable (3C-2V, 5C-2V) is preferabie to obtain better performance of the tuner.
(To use of a 300 ohm FM outdoor antenna, connect to the 300 ohm terminals.)
e AM ANTENNA
Attach the accessory AM loop antenna to the antenna holder on the back panel.
Connect the leads to AM and GND terminal. Use this terminal also for an outdoor antenna.
Orient the loop antenna horizontally to obtain optimum reception. Where broadcast stations are distant and only weak signals are
' received, or where signals are blocked by obstacles, install an AM outdoor antenna.
e GROUNDING
If there is reception noise, use of grounding wire is recommended.
Connect a thick insulated wire to the "GND" terminal, and attach the unconnected bare end to a metal water pipe, grounding rod, or
grounded copper plate.
* Never connect the grounding wire to a gas pipe. This could cause fire or explosion.
CONNECTIONS
FM OUTDOOR ANTENNA 75 ohm COAXIAL CABLE
A3 Open the cover
Z 2 push CD player VCR-VIDEO DISK
> > — = =
75 ohm ae = ee if ited
300 ohm 11 ANTENNA Sg? ea asessae de 0 at Naess So
FM INDOOR ANTENNA ANTENNA eA —- EY ha laa
© C) O
300 ohms ANTENNA
COAXIAL ADAPTER
FEEDER -
2
300 ohm
TERMINALS rat ad :
FM anrewa] @) ©)
ADAPTER
{An accessory)
Speaker (A)
| A.
(es i
Connect the antenna lead
to the antenna adapter
WaaneNc sence suns oe et WHE
Ans meet come KtCTOO
ars ora,
)@0®
(DRA-625R only)
3.5 mm
MINI JACK
jee sd
eG | > ee aes =z
AM OUT DOOR TAPE DECK 2
uYU Attach to the holder ANTENNA
ss essai 7
(E essai 1]
AM COOP ANTENNA | 2 ee See OES ol
2 [ere Fe ee |
U GROUND TAPE DECK 1 POWER AMP
nels (L, R). Connect the speaker pairs to the | 2.-:«'Twist the wire strands.
SPEAKER terminals A or B on the back panel. 3. Loosen the speaker terminald,
insert the wire lead portion of
the code, and then tighten the
termihnals.
Connections must be made with power cord
disconnected.
QO ©®
>)
SPEAKER CONNECTION 1. Peel off the sheathing from the Cra) C=>
Confirm polarity (+, -) and left and right chan- end of the cord.
> >