Configuration Kmus 100; Measuring Range Selection By Dip-Switch - promesstec WTR 120 User Manual

5.3 Configuration KMUS 100

The KMUS 100 is configured using a potentiometer and four DIP switches. Configu-
ration on the PC is not necessary.

5.3.1 Measuring range selection by DIP-switch

Four DIP-switches can be used to set 12 different measuring ranges. These are lis-
ted in the table below.
The query for the measuring range is permanent. Thus, the voltage supply does not
have to be interrupted after a change of the measuring range. The recognition of the
sensor (Pt 100/Pt 1000) is also done automatically during operation.
Attention: For Pt 1000 only the ranges 1..5 are available.
promesstec GmbH I Niedersachsenstraße 4 I D-48465 Schüttorf I Tel.:+49 (0)5923/ 90 229 0 I Fax:+49 (0)5923/ 90 229 29
Jumper = 1: plugged
Jumper = 0: not plugged
E-Mail: office@promesstec.com I Internet: www.promesstec.com
14