Table of Contents
Advertisement
The configuration options include the display orientation, the scaling of the current
output and the overflow and underflow behavior of the measuring range. In addition,
the status, the measured value and the current value are read out in real time.
5.1.2 pmtKonfigTool - connection between WTR 120-DMU and PC
Loosen the cover of the WTR 120 to access the USB C interface of the DMU.
Connect the transmitter to the PC using a standard USB C cable.
ATTENTION: WTR 120 restarts after connection via USB! Now start the Windows
software "pmtKonfigTool".
To access the display, the correct COM port must first be selected. All COM ports are
listed in the "Port" drop-down list. The button updates the drop-down list. As soon as
a connection has been successfully established, the status changes to "Connected"
and the name of the connected device is displayed.
5.1.3 pmtKonfigTool – read
As soon as a connection to the DMU has been established, the settings are read and
displayed in the software. The status, temperature and current value are conti-
nuously updated. It is also possible to press the "Read" button to read and display all
settings again.
5.1.4 pmtKonfigTool – write
To change the DMU settings, the desired values must be entered into the Windows
software and the appropriate options selected. However, the settings are only ap-
plied once the "Write" button has been pressed. If the writing process cannot be car-
ried out successfully, the old DMU settings will be displayed again.
5.1.5 pmtKonfigTool – factory settings
By pressing the "Factory settings" button, all parameters and settings are reset to the
delivery state.
Factory settings:
promesstec GmbH I Niedersachsenstraße 4 I D-48465 Schüttorf I Tel.:+49 (0)5923/ 90 229 0 I Fax:+49 (0)5923/ 90 229 29
Display: 0°
Fault current: activated
Measuring range Min.: - 50.0 °C
Measuring range Max.: +150.0 °C
E-Mail: office@promesstec.com I Internet: www.promesstec.com
11
Advertisement
Table of Contents
