Tsp Parameters - Fondital ANTEA Monothermal CTFS 40 Installation - Use - Maintenance

Table of Contents

Advertisement

3.14 TSP parameters

The boiler operation is controlled by several parameters.
To modify parameters press buttons Reset and - CH together for 3 seconds.
Scroll through the parameters by pressing CH +/- buttons.
As soon as you reach the one to be modified, press ok.
The
symbol turns on to indicate that you can edit the parameter value.
The parameter value can be edited using CH +/- buttons.
To confirm modification press Ok.
To exit the parameter editing mode press button Reset.
Parameter
P0 - TSP0
P3 - TSP3
P6 - TSP6
P7 - TSP7
P10 - TSP10
P11 - TSP11
Heating thermostat timing
P12 - TSP12
CH power rising ramp timer
Timer for CH post-circulation,
P13 - TSP13
freeze protection and flue
Water hammer protection delay,
P15 - TSP15
Ambient thermostat/remote
P16 - TSP16
P17 - TSP17
Multifunction relay setting
P27 - TSP27
Heating timer reset temperature
P28 - TSP28
management of deviating valve
Setting of default parameters
P29
(except P0; P1; P2; P17; P28)
Tab. 9 Limits to be set for TSP parameters and default values in relation to boiler type (TSP0) - I
36
Description
Fuel gas type
Boiler type selection
Ignition power setting
CH maximum output
Heating output curves
cleaning function
configurable
control reading delay
Hydraulic setting for
relay
Instructions for the installer
Configurable value
Default values
range
According to the
0 ÷ 1
According to the
1 ÷ 3
0 ÷ 100 % (min-max)
10 ÷ 100%
0 ÷ 3
0 ÷ 10 min.
0 ÷ 10 min.
0 ÷ 180 sec.
0 ÷ 3 sec.
0 ÷ 199 sec.
0, 1, 3
35 ÷ 78 °C
0 ÷ 1
0 ÷ 1
0 = LPG; 1 = natural gas
model
1 = combined instantaneous; 2
= heating only; 3 = with water
model
With P6=0 ignition with ramp.
With P6≠0 ignition at the set
0%
power (P6=1 minimum power ÷
P6=100 maximum power)
100%
1,5
Resolution 0.05
4
1
30
0
0
0 = shut-down and malfunction;
1 = ambient thermostat request
0
1/Remote control 3 = ambient
thermostat request 2
40 °C
0 = recirculating pump +
0
deviating valve; 1 = double
0 = user parameters; 1 = default
0
parameters
Notes
heater
n.a.
n.a.
n.a.
n.a.
n.a.
n.a.
n.a.
pump

Advertisement

Table of Contents
loading

Table of Contents