Table of Contents
Advertisement
3.6
Air intake and flue gas venting system
Flue gas discharge into the atmosphere and air intake/flue gas venting systems must comply with applicable laws and standards in the
country of installation that are considered as fully transcribed herein.
When positioning the boiler exhaust terminals onto the wall, comply with the distances specified in the applicable standards and regulations
in force in the Country of installation, which are herein considered as entirely transcribed.
DANGER
The boiler is equipped with a safety device for flue gas exhaustion check.
It is strictly forbidden to tamper with and/or prevent operation of such safety device.
Should an air/flue gas system malfunction occur, the device will shut-down the boiler by interrupting the gas supply to the boiler
and the LCD will display the E03 code.
In this case it is necessary to have safety device, boiler and the air intake/flue gas venting ducts promptly checked by a service
centre or a qualified service engineer.
In case of repeated stops, it is necessary to have safety device, boiler and the air intake/flue gas venting ducts checked by a service
centre or a qualified service engineer.
After each operation on the safety device or the air suction/flue gas exhaust system, it is necessary to perform a functional test of
the boiler.
In case it is necessary to replace the safety device use only original spare parts supplied by the Manufacturer.
To reset the combustion gas exhaust control device operation it is necessary to press "Reset".
DANGER
Damage and/or injury caused by incorrect installation and/or incorrect use and/or unauthorized changes to the boiler and/or non-
observance of the manufacturer's instructions and/or of the relative standards/laws in force in the country of installation, shall
release the manufacturer from any and all liability.
24
Instructions for the installer
Advertisement
Table of Contents
