Toro TurfMaster HDX 22215 Service Manual page 73

Traction Cable Installation (continued)
30 Inch TurfMaster® HDX WPM
3432-730 Rev A
g297895
8. Line up the RH side height-of-cut notch with bolt. Slide the transmission to
the left.
g297894
9. Put anti-seize inside the axle bearing before sliding over the shaft. Install the
axle bearing housing assembly over the axle. Line up the mounting hole
on the bearing housing assembly to the weldment hole. Install the bearing
retainers in the rear axle weldment and rear height-of-cut plate for alignment
purposes before securing the transmission to the frame. Install the 5/16–18
inch bolt to the axle weldment. Torque bolt to 160 ± 16 in-lbs. (18 ± 2 Nm).
Figure 84
Figure 85
Page 5–29 Controls: Service and Repairs