Advertisement
Other Useful Information (Cont.)
Cleaning the lint filter
To remove the filter, open the door to
the clothes dryer (Fig. 5a) grip the lint
filter and pull it straight up and out of
the drum (Fig. 5b).
Open the filter (Fig 5c), then remove
any lint, fibres and textile threads from
the filter by hand or with a soft piece
of cloth (Fig. 5d).
Close the lint filter and place it back
into its housing.
A layer can build up on the filter pores
that can cause clogging of the filter
after using the dryer for a while. Wash
the lint filter with warm water to remove the layer that builds up on the lint filter surface.
Dry the lint filter completely before reinstalling it.
The lint trap MUST be cleaned before or after each use.
• Do not use the appliance without the filter. The lint filter must be in place when
drying.
• Clean the lint filter and the inner surfaces of the loading door after each drying
process.
Emptying the water container
The water container collects all the water from the condenser
(unless you have the drain hose connected). The water
container needs to be emptied after every drying cycle, the
tank full
indicator will remind you to do so. This indicator
will also illuminate if the water container is full while the dryer
is in operation. Should that happen, the program will stop.
In order to continue the program, you must empty the water
container first.
Holding the water container with two hands, pull it out of the
dryer housing (Fig. 6), keeping it level to avoid spilling. Then,
tilt it over a sink and pour out the condensate water (Fig. 7).
Insert the empty water container back into its space in the
dryer housing.
To restart the program, press the Start/Pause button.
Fig. 5
WARNING!
After Sales Support
1300 886 649 |
a)
c)
Fig. 6
Fig. 7
tempo.org/support
b)
d)
23
Advertisement
