Advertisement
Instructions (Cont.)
Program options
Child lock
The heat pump dryer is equipped with a child lock which locks the buttons to prevent
unauthorised access to the controls while the machine is running.
To set the child lock, press the ON/OFF button, and select the desired program.
Press the START/PAUSE button, and then press and hold the Anti-crease and Dry
Level buttons for several seconds. When the child lock icon lights up on the display,
all buttons and knob operations are ineffective except for the ON/OFF button. (In an
emergency you can still power the machine off.)
To cancel the child lock, press and hold the Anti-crease and Dry Level buttons for
several seconds.
Dry level
For each of the available drying programs you can select one of three drying levels.
After you have started the program, you can press the Dry Level button and set the
drying level to low (H1), medium (H2) or high (H3).
NOTE: Selecting a drying level will increase the default drying time. This increase will
depend on the program and the drying level set.
Anti-crease
The anti-crease function will help minimise creasing of your load. Press the Anti-
Crease button to extend the anti-crease function for up to 120 minutes. You can
remove your laundry during the anti-crease phase.
Indicator Lights
Child lock
This indicator will appear when the child lock is in use. To turn the child lock off again,
press and hold the Anti-crease and Dry Level buttons for several seconds.
Door Open ["DOP"]
This indicator will appear when the door of the dryer hasn't been closed properly during
operation. Ensure that the door is closed and that there are no items caught in the door.
Water Tank Full
This indicator will appear when the water tank is full. Please empty the water tank,
following the instructions on pages 23-24. Ensure that the tank is clean, empty and has
been re-inserted properly before beginning or continuing a program.
Clean the filter
This indicator will appear when the lint filter needs to be cleaned (following the
instructions on page 23). Please note, the lint filter must be cleaned before or after
every cycle. Failure to do so may create a fire hazard.
After Sales Support
16
1300 886 649 |
tempo.org/support
Advertisement
