Storage; Troubleshooting - Silvercrest 281312 Operating Instructions Manual

To clean the filters
■ Turn the lid of the pusher
the pusher shaft. You can now remove the lid. The nylon brush
found inside the pusher
the arrow points to the opened lock
the closed lock
■ Hold the filter
clean it with the nylon brush
Colouring:
■ Some fruits or vegetables can permanently discolour parts of the juicer.
This is not damaging and does not impair the appliance in its functions.

Storage

If you do not intend to use the juicer for a long time, wrap the cable around the
cable retainer

Troubleshooting

Faults
The appliance is
not working.
The motor stops
still while juicing or
it turns noticeably
more slowly or
unevenly.
The pulp is moist
and you obtain too
little juice.
The juice wells out
between the edge
of the lid and
the juice tank
SFE 450 C1
, use the supplied nylon brush
. The lid now sits firmly in place.
(with the underside upwards) under running water and
on the underside of the juicer.
Possible causes
The mains plug
connected.
The appliance is not switched on. Switch the appliance on with
The clamps are not secured.
The filter is blocked.
You are working too fast.
The filter is blocked.
You are working too fast.
The filter or the juice tank
is blocked.
.
The speed setting is too high.
until the arrow points to the opened lock
. To re-close the lid, place it on the pusher so that
. Then turn it until the arrow points at
.
Connect the appliance to
is not
a mains power socket.
the On/Off switch
Close the clamps
Switch the juicer off immediately
and pull out the mains plug
Remove the blockage (see sec-
tion "Juicing").
Work a little more slowly.
Clean the filter
"Cleaning and Care").
Work a little more slowly.
Clean the filter
the juice tank
"Cleaning and care").
Use the on/off switch
select speed level 1.
:
can be
Possible solutions
.
.
(see section
and
(see section
to
GB
on
.
│ 33 ■