Disassembling The Appliance; Cleaning; Storage - Silvercrest SZP 25 D4 Operating Instructions Manual

Disassembling the appliance

Disassemble the appliance before cleaning:
Remove the lid 1.
If necessary, remove the large pressing cone 2 from the small pressing cone 3
and then remove the small press cone 3 from the sieve attachment 4/5.
Remove the sieve attachment 4/5 from the juice container 7. Then sepa-
rate the upper part 4 and the lower part 5 by pulling them apart.
If you have not already done so, turn the juice container 7 anticlockwise
and lift it off the base q.

Cleaning

RISK OF ELECTRICAL SHOCK!
► Before cleaning the appliance, pull out the plug from the mains power socket.
►
ATTENTION! PROPERTY DAMAGE!
► Do not use aggressive or abrasive cleaners, as these may damage the
surface of the appliance.
Clean the lid 1, the pressing cone 2/3, the sieve attachment 4/5, the
juice container 7 and the cover of the drive shaft 9 in a mild soap solution.
NOTE
►
Clean the base q with a slightly damp cloth. If necessary, add a little wash-
ing-up liquid to the cloth. Afterwards, wipe off with a cloth moistened only
with water to ensure that no detergent remains on the appliance.
Dry all parts thoroughly before reassembling them.

Storage

Wind the mains cable around the cable retainer w and secure the end of the
cable with the cable clamp.
Place the lid 1 back on the appliance to prevent dust accumulation.
Store the cleaned appliance in a dry place away from direct sunlight.
SZP 25 D4
Never clean the base q, the mains cable and plug under running
water and never immerse these parts in water or any other liquids.
The lid 1, the pressing cone 2/3, the sieve attachment 4/5
and the juice container 7 can also be cleaned in the dishwasher.
GB │ IE │
9 ■