Advertisement
Available languages
Available languages
lower section of the range. This will be necessary for some of the
following installation steps.
To Remove Warming Drawer:
1.
Open drawer to its fully open position.
2.
Locate the black loops on both sides of the drawer.
Drawer
3. Pull both loops forward at the same time, then pull drawer out
another inch.
Holding the drawer by its sides, not its front, gently pull it all
the way out.
"
Power Supply Cord
Direct Wire
Xe
Xe
Electrical Shock Hazard
Disconnect power before servicing.
Use a new 40 amp power supply cord.
Plug into a grounded outlet.
Failure to follow these instructions can result in death,
fire, or electrical shock.
Electrical Shock Hazard
Disconnect power before servicing.
Use 8 gauge copper or 6 gauge aluminum wire.
Electrically ground range.
Failure to follow these instructions can result in death,
fire, or electrical shock.
1.
Disconnect power.
2.
Remove the terminal block cover screws located on the back
of the range. Pull cover down and toward you to remove
cover.
A. Hold-down screws
B. Terminal block cover
12
3.
Remove plastic tag holding three 10-32 hex nuts from the
middle post of the terminal block.
4.
Add strain relief.
Advertisement
