Enable (R-Ch) Block-3 - Sony HT-ST5000 Service Manual
Active speaker system
Hide thumbs
Also See for HT-ST5000:
- Operating instructions manual (167 pages) ,
- Startup manual (2 pages) ,
- Startup manual (2 pages)
Table of Contents
Advertisement
HT-ST5000
2-29. ENABLE (R-CH) BLOCK-3
Note 1: Draw out the cable and
coaxial harness before
installation.
coaxial harness
top R-ch speaker
connection cable
CN2301
CHUKEI-WIRE board
right
side
The opposite side
is terminal side.
Push.
enable (R-ch) block
38
CHUKEI-WIRE
board cable
5 enable (R-ch) block
right side
2 Lift up the enable (R-ch) block
in the direction of the arrow.
filament tape
(sub material)
FFC 6P
FFC 6P
FFC 6P
Note 1: Draw out the three cables
CHUKEI-WIRE board cable
I
I
1 screw
(BVTP3
8)
bottom side
Note 2: Lay a soft piece of cloth
Push.
under the unit to avoid
damaging the grille assy.
before installation.
CHUKEI-WIRE
board cable
3 filament tape
(sub material)
4 FFC 6P
(CN2301)
1 screw
(BVTP3
8)
top side
Advertisement
Table of Contents
