Enable (R-Ch) Block-2 - Sony HT-ST5000 Service Manual

2-28. ENABLE (R-CH) BLOCK-2

• Continued on 2-29 (page 38).
CHUKEI-WIRE
board cable
groove
bottom side
2 Draw the CHUKEI-WIRE board
cable out of the groove.
1 Draw the top R-ch speaker
connection cable out of the
groove.
top R-ch speaker
connection cable
screw
hole
bottom
groove
side
Note 2: Press the cable into the groove
of front (R-ch) speaker block.
OK
Pass the top R-ch speaker
connection cable beside
the screw hole.
screw
hole
– –
bottom
side
groove
front (R-ch)
Note 2: Press the cable into the groove
speaker block
Note 2: Press the cable into the groove
of front (R-ch) speaker block.
front (R-ch) speaker block
front (R-ch)
speaker block
NG
The top R-ch speaker
connection cable is
overlapping the screw
hole.
screw
hole
– –
CHUKEI-WIRE board cable
of front (R-ch) speaker block.
CHUKEI-WIRE board cable
right side
front (R-ch) speaker block
ferrite
core
right
side
groove
groove
bottom side
front (R-ch)
speaker block
HT-ST5000
guide hole
ferrite core
4 Draw the ferrite core out of the guide
hole in front (R-ch) speaker block.
guide hole
3 Draw the CHUKEI-WIRE board
cable out of the groove.
5 Draw the coaxial harness
out of the groove.
bottom side
Note 1: Lay a soft piece of cloth
under the unit to avoid
damaging the grille assy.
coaxial harness
groove
Note 3: Press the coaxial harness into the groove
of front (R-ch) speaker block.
top side
37