Table of Contents
Advertisement
Attach the shoulder belt included in the tool as the
standard accessory to the hook for carrying the tool.
Remove the shoulder belt from the hook before operat-
ing the tool.
1
Fig.5
► 1 . Hook 2. Shoulder belt
Electric brake
This tool is equipped with an electric brake. If the tool
consistently fails to quickly stop after the switch trigger
is released, have the tool serviced at a Makita service
center.
Accidental re-start preventive
function
Even if you install the battery cartridge while pulling the
switch trigger, the tool does not start.
To start the tool, first release the switch trigger and then
pull the switch trigger.
ASSEMBLY
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before carrying out any work on the tool.
CAUTION:
Be sure to install accessories
according to the instruction manual. Otherwise
accessories may come off and cause injury.
Removing the outer and inner sleeves
CAUTION:
ter to enter the insides of the tool when removing
or installing the outer and inner sleeves.
1.
Loosen the two screws while holding the outer
sleeve. The outer and inner sleeves will be pushed up
by the springs built into the tool.
2
Fig.6
► 1 . Outer sleeve 2. Screw
2.
Press the pin down to remove the inner sleeve
from the outer sleeve.
Fig.7
► 1 . Inner sleeve 2. Pin 3. Outer sleeve
NOTICE:
Be careful not to drop the inner sleeve
when removing it.
NOTICE:
Do not remove the tip rod, tip rod
spring, and inner sleeve spring from the tool.
Fig.8
► 1 . Tip rod 2. Tip rod spring 3. Inner sleeve spring
8 ENGLISH
Be careful not to allow foreign mat-
1
2
1
2
3
1
2
3
Advertisement
Table of Contents
