Table of Contents
Advertisement
Section 7—2465 Operators
OPTIONS AND ACCESSORIES
INTRODUCTION
This section contains a general description of instrument
options available at the time of publication of this manual.
Also included is a completelist (with Tektronix part num-
bers) of standard accessories included with each instrument
and
a
partial
list of optional
accessories. Additional
information about instrument options, option availability,
and other accessories can be obtained either by consulting
the current Tektronix Product Catalog or by contacting
your local Tektronix Field Office or representative.
OPTION 11
Option 11 provides two probe-power connectors on the
rear panel of the instrument. Voltages supplied at these
connectors
meet
the
power requirements of standard
Tektronix active oscilloscope probes.
OPTION 1R
When the 2465 Oscilloscope is ordered with Option 1R,
it is shipped in a configuration that permits easy installation
into a 19-inch-wide electronic-equipment rack.
An optional rear-support kit also is available for use
when rackmounting the 2465. Using this optional rear-
support kit enables the rackmounted instrument to meet
all
electrical
and
environmental
specifications of the
standard 2465 Oscilloscope.
Connector-mounting holes are provided in the front
panel of the rackmounted instrument. These enable con-
venient accessing of the four BNC connectors (CH 2
SIGNAL OUT, A GATE OUT, B GATE OUT, and EXT Z
AXIS IN) and the two PROBE POWER connectors located
on the
rear panel. Additional cabling and connectors
required to implement any front-panel access to the rear-
panel connectors are supplied by the user; however, these
items can be separately ordered from Tektronix.
Complete rackmounting instructions are provided in a
separate document shipped with the 2465 Option 1R.
These instructions also contain appropriate procedures to
convert a standard instrument into the Option 1R con-
figuration by using the rackmounting conversion kit.
POWER CORD OPTIONS
Instruments are shipped with the detachable power-cord
configuration ordered by the customer. Descriptive infor-
mation
about the
international power-cord options is
provided in Section 2, 'Preparation for Use.'' The following
list identifies the Tektronix part numbers for the available
power cords and associated fuses.
Option A1 (Universal Euro)
Power cord (2.5 m)
161-0104-06
Fuse (1.6 A, 250 V,
5 x 20 mm, Quick-acting)
159-0098-00
Option A2 (UK)
Power cord (2.5 m)
161-0104-07
Fuse (1.6 A, 250 V,
5 x 20 mm, Quick-acting)
159-0098-00
Option A3 (Australian)
Power cord (2.5 m)
161-0104-05
Fuse (1.6 A, 250 V,
5 x 20 mm, Quick-acting)
159-0098-00
Option A4 (North American)
Power cord (2.5 m)
161-0104-08
Fuse (2 A, 250 V, AGC/3AG,
Fast-blow)
159-0021-00
Option A5 (Switzerland)
Power cord (2.5 m)
161-0154-00
Fuse (1.6 A, 250 V,
5 x 20 mm, Quick-acting)
159-0098-00
7-1
Advertisement
Table of Contents
