GE GLDT696D00SS Installation Instructions Manual page 6

Installation Instruction
STEP 2 - ADJUST LEVELING LEGS
eMove the dishwasher close to the installation
location and lay it on its back.
Adjust to
Installation
Height
Figure 8
*Measure installation height and dishwasher height.
Extend leveling legs out from the dishwasher base,
1/4'less than installation height.
STEP 3 - REMOVE TOEKICK
Remove the 2 toekick screws. Lift off the 2 piece
toekick.
a
~2-Screws"
Figure?
STEP 4 - INSTALL POWER CORD
Skip this step if dishwasher will be direct wired.
The power cord and connections must comply with
the National Electrical Code, Section 422and/or local
codes and ordinances.
Recommended power cord length is 54" min. and 64" max.
A B Check That White, Black and
Remove Green Dishwasher Wires Are Threaded
Junction Box Thru Hole in Back
Cover t
D Use UL Listed
Connect incoming
power cord white (or ribbed)
to dishwasher white. Black
{or smooth) to black. Ground to dishwasher green
wire. Use UL listed wire nuts of appropriate size.
Replace junction box cover . Be sure wires are not
pinched under the cover .
STEP 5 - INSTALL 90° ELBOW
Wrap 90 elbow with thread seal tape.
Install a 90 elbow onto the water valve.
Figure 11 Sed Tape
*Do not over Tighten 90° elbow, water valve bracket
could bend or water valve fitting could break.
Position the end of the elbow to face the rear of the
dishwasher .