MIQ/R6
3.5
Cable glands
All electric cables are fed from below via prepared openings in the enclosure of
the MIQ/R6. Cable glands with different clamping ranges are included with the
MIQ/R6 to provide sealing between the cable and enclosure as well as for strain
relief. Select the matching cable gland for the respective cable diameter:
Small, clamping range 4.5 to 10 mm. This cable gland is suitable for all
Large, clamping range 7 to 13 mm. This cable gland is required for cable
General
Observe the following points when attaching connecting wires to the terminal
installation
strip
instructions
Shorten all wires to be used to the length required for the installation
Always fit all the ends of the wires with wire end sleeves before connecting
ba75541d07
03/2018
All manuals and user guides at all-guides.com
Electrical connections: General instructions
IQ S
N
sensor cables.
ENSOR
ET
sealing ring 20 x 15 x 1 mm
cable gland M16
blind plug
sheaths with an outside diameter of more than 10 mm and is screwed into the
enclosure via an extension piece.
sealing ring 20 x 15 x 1 mm
extension piece M16/M20
sealing ring 24 x 19 x 2 mm
cable gland M20
If necessary, you can order more large cable glands in a set of 4
pieces (Model EW/1, Order No. 480 051).
Installation
11