FlowLine EchoBeam LR85 Series Manual page 62

Appendix
Register Mapping:
0x0000 Distance measurement in centimeters (read only)
0x0001 Distance measurement in millimeters (read only)
0x0002 Level measurement in centimeters (read-only)
0x0003 Level measurement in millimeters (read-only)
0x0004 Measurement status (read-only);
0 = Normal
1 = Comm Err - Display not connected or broken
2 = EEProm Err - write failure, EEPROM is broken
3 = PLL Err - antennae circuit is broken
7 = SYSBUSY - Slow response due to large data request or low supply voltage
8 = LOWPOWER - Low Voltage - check power supply
14 = NOSIGNALERR - No valid echo signal
0x0005 Range Value in centimeters (read and write);
0x0006 Blanking distance (dead zone) in centimeters (read and write);
0x0007 Low-level (Sensor Height) adjustment in centimeters (read and write);
0x0008 High-level (Fill-Height?) adjustment in centimeters (read and write);
0x0009 Signal Strength (read-only)
0 = Min
150 = Max
0x000A Distance measurement in millimeters (4-byte Integer, read-only, high 16 bits)
0x000B Distance measurement in millimeters (4-byte integer, read-only, low 16 bits)
0x000C Distance measurement in meters (4-byte float, read-only, high 16 bits)
0x000D Distance measurement in meters (4-byte float, read-only, low 16 bits)
0x000E Level measurement in millimeters (4-byte integer, read-only, high 16 bits)
0x000F Level measurement in millimeters (4-byte integer, read-only, low 16 bits)
0x0010 Level measurement in meters (4-byte float, read-only, high 16 bits)
0x0011 Level measurement in meters (4-byte float, read-only, low 16 bits)
0x0012 Temperature (4-byte float, read-only, upper 16 bits)
0x0013 Temperature (4-byte float, read-only, lower 16 bits)
| 62
Section Nine
AD310320 Rev A