Table of Contents
Advertisement
Troubleshooting
PRoblem
Not separating well.
(Only a tiny amount of dust
should reach the vacuum)
Material not dropping
into the dust container.
Low air volume
Drum collapsing
Hose pulling off
20
Oneida Air Systems
c auSe
Solution
Air leaks in the
1. Check for leaks between the Low-Pro Lid Separator and the bucket.
bucket
2. Check for holes or leaks in the bucket.
Collecting large,
1. Large, bulkier material might swirl. Restart or temporarily cut off
bulky material
System clogged
1. Clean vacuum and the vacuum filter per the manufacturer's specs.
2. Check all hose connections for a blockage in the hose.
Blocked airflow
1. Ensure the end of the hose isn't blocked.
Hose connections
1. Due to the varied hose diameters, flexible couplers can be used.
not tight
2. Use a hose clamp.
3. Wrap the inlet and outlet of the Low-Pro with a layer of electrical
4. Secure hose with a sheet metal screw.
airflow to drop material down.
They are available at local hardware stores in the plumbing section.
tape to increase the friction fit.
Advertisement
Table of Contents
