Table of Contents
Advertisement
Assembly Instructions (Continued)
Snap the Low-Pro assembly onto your bucket – either (F) or
9
your own – and ensure that the Latches (D1) are fully seated
with the lip of your bucket [FIG. 9]. The Wing Nut (D5) can
be loosened to slide the Latch tighter to the bucket lip.
Note: It's normal for the Low-Pro to fit loosely but it will seal
firmly shut under vacuum pressure. To empty your bucket, lift
up on the latches and pull up on the Low-Pro.
FIG. 9
If you purchased the Deluxe Unit, connect the Low-Pro's
10
(A) top outlet port to your vacuum with Hose (K) and both
Elbows (L) as shown in [FIG. 10a].
If you purchased the DIY Unit, connect the Low-Pro's top
outlet port to your vacuum with your hose [FIG 10b].
Connect the Low-Pro's side inlet port to your tool with your
vacuum's hose [FIG. 10a] [FIG. 10b].
Note: Both ports accept standard 2.5" hose cuffs (OD ≈ 2.25").
L
To Tool
To vacuum
K
A
To Tool
A
To vacuum
L
FIG. 10a
FIG. 10b
16
Oneida Air Systems
Advertisement
Table of Contents
