Basket Lift Arm Adjustment - Vulcan-Hart GRC35 Service Manual

GR SERIES GAS FRYERS - SERVICE PROCEDURES AND ADJUSTMENTS

BASKET LIFT ARM ADJUSTMENT

1. With frying oil at room temperature, verify the oil level
is between MIN & MAX lines in fry tank. Add frying oil
as needed.
NOTE: Frying oil will expand when heated. Do not fill
the fry tank past the MAX line.
2. Turn power switch on and set temperature to 350°F.
Allow the frying oil to reach set temperature.
3. Check basket lift operation.
A. If necessary, adjust as outlined below.
4. When basket is in the up position, the bottom of the
basket should be out of the oil. When basket is in the
down position, the bottom of the basket should clear
the crumb screen and the product should be
submerged.
A. To adjust, remove basket arm from lift shaft,
loosen stop nut and turn height adjustment bolt to
raise or lower basket arm as required. Both
baskets should be same height.
B. Re-tighten stop nut when complete.
NOTE: If adjustment is to low, when the basket is
lowered, it will disengage from basket arm.
– 23 –
F-25114 Rev.A (07-03)