Sony STR-DG800 Operating Instructions Manual page 37

Explanation Remedies
Error codes
When an error is detected during Auto
Calibration, an error code will appear on the
display cyclically after each measurement
process as follows:
Error code _ blank display _ (error code
blank display) a) _ PUSH ENTER
a)Appears when there are more thau
oue
error code.
To rectify the error
1 Record down tile error code.
2
Press the control button.
3 Press I/(.D to turn oft" tile receiver.
4 Rectify the error.
For details, see "Error code and remedies"
below.
5 Turn on the receiver and perl\wm Auto
Calibration again (page 36).
Error code and remedies
Error Explanation Remedies
code
ERROR The euviromneut Make sure the
CODE I0 is too noisy, environment is
quiet during Auto
Calibration.
ERROR The speakers are Place your speakers
CODE I I placed too near to further away from
the optimizer the optimizer
microphone, microphone.
ERROR Front speakers Check the front
CODE 20 are not detected speaker
or only one frout couuectiou.
speaker is
detected.
ERROR Only one Check the surround
CODE 21 surround speaker speaker
is detected, connection.
Error
code
ERROR
CODE 22
ERROR
CODE 23
Only one
surround back
speaker is
detected.
Surround back
speaker is
detected but
surro/lud
speakers are not
connected.
Check the surround
back speaker
connection, llyou -_'
connect only one
surround back
speaker, connecl it
to the SPEAKERS _"
SURROUND "_
BACK L lerminah
Be sure to couuecl
the surround
speakers.
Warning codes
During Auto Calibration, the warning code
provides information on the measurement
result. The warning code will appear on the
display cyclically as follows:
Warning code _ blank display _ (warning
code _ blank display) b) _ PUSH ENTER
b)Appears when there are more than one warning
code.
You can choose to ignore the warning code as
the Auto Calibration fimction will
automatically adjust the settings. You can also
change the settings manually.
To change the settings
manually
1 Record down the warning
code.
2 Press the control button.
3 Press I/(.D to turn off the receiver.
4 Follow the solution provided in the
"Warning code and solution" below.
5 Turn on the receiver and perform Auto
Calibration again (page 36).
continued_
37us