Personal Protective Equipment (Ppe); Storage - EndurEnergy Systems ESP-BCU HL User Manual

Personal protective equipment (PPE)

4.4
When handling the battery control unit, the following safety gear should be worn. Installers
must comply with the relevant requirements of UL1973, IEC 62040, and IEC 62619, or
applicable domestic legislation and other relevant international standards.
Insulated gloves

Storage

4.5
If the battery control unit is not going to be installed immediately and needs to be stored
for a long period, please choose an appropriate location for storage. Follow these
instructions for storage:
⚫
Do not stack more than four boxes.
⚫
The recommended storage temperature for the battery control unit is in the range of -
20°C to 30°C.
⚫
Avoid exposing the battery control unit to water.
⚫
If the battery control unit needs to be stored for over 3 months, the auxiliary battery
will discharge at a minimum rate and the capacity may degrade depending on the
storage time.
⚫
The boxes should be stored upright as shown in the following figure and should not
be stacked upside down.
Safety goggles
13
Dielectric Safety shoes