Rear Panel - Yamaha QX5 Owner's Manual

START (ENTER) Start recording or play from the beginning of the song. When editing, executes the
selected function.
* Switches [F1]-[F4] perform the function indicated in the LCD above
the corresponding numbers [F1] - [F4].
F1 (JOB) When performing a Setup, Edit or Load/Save function, [F1] steps through the jobs.
F2 (CURSOR) When performing a Setup, Edit or Load/Save function, moves the cursor.
F3(<2) When performing a Setup, Edit or Load/Save function, decrements the data
indicated by the cursor.
EA) When performing a Setup, Edit or Load/Save function, increments the data
indicated by the cursor.
SHIFT Used to access the functions printed in purple below the keys. Holding down
SHIFT] reverses the movement of the and [CURSOR] keys.
REAR PANEL
TAPE
OUT N FOOT $w CLICK OUT
MIDI THRU All messages received at MIDI IN are sent unchanged from this terminal.
MIDI OUT Sequence playback and other MIDI messages are sent from here. You may set the
MIDI OUT to echo back messages received at MIDI IN.
MIDI IN MIDI messages coming in to this terminal can be recorded by the QX5.
TAPE OUT In play and record mode, this sends an FSK tape sync signal. In load/save mode,
it sends sequence data to tape.
TAPE IN In play and record mode, this receives an FSK tape sync signal. in load/save mode,
it receives sequence data from tape.
FOOT SW An optional footswitch such as the FC4 or FC5 can be used to start, stop or continue
playback or recording.
CLICK OUT The metronome signal is output from this jack to an external mixer or amp. The
internal click tone will go off if this is connected.