Advertisement
Adtran
Features
The features of the SDG-8622 include the following:
2x 2.5 Gigabit Ethernet RJ-45 interfaces
l
4t4r 802.11ax @ 2.4GHz with up to 40 MHz channel bandwidth
l
4t4r 802.11ax @ 5GHz (High) with up to 160 MHz channel bandwidth
l
4t4r 802.11ax @ 5GHz (Low) with up to 80 MHz channel bandwidth
l
1x USB 3.0 Type A interface
l
1x Reset button
l
1x Serial Console interface
l
This quick start describes how to install and connect to the device.
Installing the SDG-8622 Mesh AP
l
Understanding the Status LEDs
l
Logging Into the SDG-8622
l
Product Specifications
l
Installing the SDG-8622 Mesh AP
NOTE
Refer to the national, state and local electrical codes for the requirements for power, grounding,
wiring, and installation methods.
Package Contents
Adtran's SDG-8622 Wi-Fi 6 Mesh AP
l
15V DC power adapter (USB-C)
l
Ethernet cable
l
Quick Install Guide
l
CAUTION!
The product is intended for indoor use only. Ethernet and attached equipment are intended for use
within the same building with equipotential bonding, and not intended to be placed in separate
buildings or structures. Failure to deploy as described could result in permanent damage from
lightning or other electrical events and voids the warranty. Furthermore, all connections from
outside of the building must be disconnected prior to use.
Prior to Installation
Before installing the equipment, inspect the device. If damage has occurred during shipping, file a claim with the carrier,
and then contact Adtran Customer Support. For more information, refer to the product warranty available online at
https://adtran/wp_support_warranty.
Required Tools
No special tools are required for installing the SDG-8622.
Mounting Options
The SDG-8622 can be placed on a desk or table. Be sure to route and secure the cables in a manner that will prevent
damage. These options are described below.
6SDG8622-13A
Package Contents
2
Advertisement
