ADTRAN NetVanta 3100 Series Quick Start

Quick Start
G S
ETTING TARTED
This NetVanta unit ships with a statically assigned IP address of 10.10.10.1 and the ability to connect to a
Dynamic Host Control Protocol (DHCP) network and receive an IP address assignment from a DHCP server.
When connecting to a DHCP network, this unit supports Zero-Touch Provisioning, allowing the NetVanta router
to download and apply configuration parameters from a configuration management server.
Regardless of the method you use to connect the NetVanta unit to the network, two configuration methods are
available for your NetVanta unit:
■ Web-based graphical user interface (GUI)
■ ADTRAN Operating System (AOS) command line interface (CLI)
The GUI lets you configure the main unit settings and provides online guidance and explanations for each
setting. However, using the AOS CLI may be necessary for more advanced configurations.
A
CCESSING THE
You can access the GUI from any web browser on your network in one of two ways:

Connecting via the Static IP Address

1. Connect the unit to your PC using the unit's GIG 0/1 port and an Ethernet cable.
2. Set your PC to a fixed IP address of 10.10.10.2. To change your PC IP address, navigate to Computer
> Control Panel > Network Connections > Local Area Connection > Properties > IP (TCP/IP) and
select Use this IP Address. Enter these parameters:
■ IP Address: 10.10.10.2
Subnet Mask: 255.255.255.0
■
■ Default Gateway: 10.10.10.1
You do not need to enter any domain naming system (DNS) server information. After the information is
entered, select OK twice, and close the Network Connections dialog box. If you cannot change the
PC's IP address, you will need to change the unit's IP address using the CLI. (Refer to
Configuring the Unit's IP Address"
3. Open a web browser and enter the unit's IP address in your browser address line as follows:
http://10.10.10.1. The default IP address is 10.10.10.1, but if you had to change the unit's IP address
using the CLI, enter that address in the browser line.
4. You will then be prompted for the user name and password (the default settings are admin and
password).
5. The initial GUI screen appears. You can access initial setup information by selecting Setup Wizard from
the menu on the left.

Connecting via the DHCP Client Address

1. Connect the router to an existing network that supports DHCP using the unit's GIG 0/1 Gigabit Ethernet
port. The NetVanta unit will automatically request an IP address assignment from the DHCP server.
2. Check the DHCP server and record the IP address assigned to the NetVanta unit.
3. Open a web browser on any network PC that can route to the IP address recorded in Step 2, and enter
the NetVanta unit's IP address.
4. The initial GUI screen appears. You can access initial setup information by selecting Setup Wizard from
the menu on the left.
61700340F1-13D
NetVanta
NetVanta 3140 Fixed Port Router
GUI
on page 2 for instructions.)
March 2021
61700340F1-13D
P/N: 1700340F1
1700341F1
t"Manually
1