Call Waiting; Paging The Handset; Intercom; Setting The Handset Ringer - VTech vt2961 User Manual

BASIC OPERATIONS

CALL WAITING

If you subscribe to Call Waiting, you will hear a tone while on the phone as you receive a
second call. If you subscribe to Caller ID on Call Waiting, the Handset (or Base) will display
who the second caller is before you answer.
8
7 9
0
TONE OPER
HOLD PROG REDIAL/PAUSE
FLASH
CONF

INTERCOM

PAGING THE HANDSET

• To make the Handset ring, press INTERCOM on the Base.
• To stop the ringing, press OFF on the Handset, or Base Unit.
ANSWER
MEMO ANSWER ON/OFF
TIME/SET SELECT
MENU
MENU
DELETE
SPARE
NEW CALL
CHARGING BATTERY
3
1 2
MAIL BOX
PLAY/STOP
REPEAT SKIP
VOLUME
MUTE INTERCOM
CONF HOLD FLASH
LINE 1 OFF LINE 2
MIC
3. To answer the call, press INTERCOM on the Handset.
4. To end an Intercom call, press OFF on either the Handset or the Base.
L 2

SETTING THE HANDSET RINGER

1. Press PROG on the Handset.
2. Press #.
3. Press SELECT.
4. Press or to select LINE1 or LINE2.
5. Press SELECT.
To answer Call Waiting, press FLASH. To return to your original call,
press FLASH again. This procedure is the same for Handset and
Speakerphone calls.
INTERCOM
(Conversation between the Base and Handset)
From the Handset:
Press INTERCOM.
The Base Unit will ring, and the intercom call will be automatically
connected.
From the Base:
1. Press INTERCOM.
2. The Handset will ring. The Base
Unit and Handset will display:

BASE UNIT RINGER

The Base Unit ringer is controlled by switches located in
the right edge of the Base full stop Each line can be set
to OFF, LOW, or HIGH volume.
13