Table of Contents
Advertisement
Figure 10: Masking unwanted areas
The third and final settings page covers area Masking and Allocating. Masking a section of the
detection area becomes a non-detectable segment while the rest of the detection area remains
detectable.
Enabling area allocating creates independent detection segments in the scanned area. Up to
eight patterns can be allocated in the LD308SH; however, four patterns is set as default. This is
commonly used with CCTV or independent zoning.
The scan area for the LD204S is divided into 10,000 segments, 7.8in squares.
The LD308SH is divided into 20,000 segments, 12in squares.
To save all detector settings either click the save button located at the bottom right corner of the
screen or by clicking the red save button in the task bar.
Figure 11: Zone selection using area allocating
12
Advertisement
Table of Contents
