The Rbrc Seal - VTech vt20-2481 User Manual

product. There are no other express warranties. No one is authorized to make
modifications to this limited warranty and you should not rely on any such
modification.
State Law Rights: This warranty gives you specific legal rights, and you may
also have other rights which vary from state to state.
Limitations: Implied warranties, including those of fitness for a particular
purpose and merchantability (an unwritten warranty that the product is fit
for ordinary use) are limited to one year from date of purchase. Some states
do not allow limitations on how long an implied warranty lasts, so the above
limitation may not apply to you.
• In no event shall VTECH be liable for any indirect, special, incidental,
consequential, or similar damages (including, but not limited to lost profits
or revenue, inability to use the product, or other associated equipment, the
cost of substitute equipment, and claims by third parties) resulting from the
use of this product. Some states do not allow the exclusion or limitation of
incidental or consequential damages, so the above limitation or exclusion may
not apply to you.

The RBRC Seal

R
The RBRC Seal on the nickel-cadmium battery indicates that VTech
R
Communications, Inc. is voluntarily participating in an industry
program to collect and recycle these batteries at the end of their useful
lives, when taken out of service within the United States and Canada.
The RBRC program provides a convenient alternative to placing used
R
nickel-cadmium batteries into the trash or municipal waste,which may be illegal in your
area.
VTech's partnership with RBRC R makes it easy for you to drop off the spent
battery at local retailers participating in the RBRC
VTech product service centers.Please call 1-800-8-BATTERY
Ni-Cd battery recycling and disposal bans/restrictions in your area.VTech's
involvement in this program is part of its commitment to protecting our
environment and conserving natural resources.
RBRC is a registered trademark of Rechargeable Battery Recycling Corporation.
R
50
prog r am or at authorized
R
for information on
TM
This equipment complies with Parts 15 of the Federal Communications
Commission (FCC) rules for the United States. It also complies with regulations
RSS210 and CS-03 of Industry and Science Canada. Operation is subject to the
following two conditions: (1) this device may not cause interference, and (2)
this device must accept any interference, including interference that may cause
undesired operation of the device.
A label is located on the underside of the Base Unit containing either the FCC
registration number and Ringer Equivalence Number (REN) or the IC
registration number and Load Number. You must, upon request, provide this
information to your local telephone company.
This equipment is compatible with inductively coupled hearing aids.
Should you experience trouble with this telephone equipment, please contact:
CUSTOMER SERVICE at 1-800-595-9511. In Canada, call VTECH Electronics
at 1-800-267-7377.
For repair/warranty information. The telephone company may ask you to
disconnect this equipment from the line network until the problem has been
corrected.
Warning: Changes or modifications to this unit not expressly approved by
the party responsible for compliance could void the user's authority to operate
the equipment.
The equipment has been tested and found to comply with part 15 of the FCC
rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try and correct
the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet or on a circuit different from that
to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
If this equipment was approved for cornection to the telephone network prior
to July 23,2001, it was registered with the Federal Commissions (FCC) in
accordance with Part 68 of its rules. If the equipment was approved after that
date, it complies with the Part 68 rules and with Technical Requirements for
Connection of Equipment to the Telephone Network adopted by the
51