Table of Contents
Advertisement
The original Handset that is shipped with your GIGAPHONE system will be
automatically registered to the Base. This Handset is HANDSET 1.
As you register additional Handsets to the system, they will be assigned
extension numbers in the following order: HANDSET 2, HANDSET 3,
HANDSET 4, etc.
Whenever a charged Handset battery pack is installed, the Handset will
automatically begin SEARCHING FOR BASE (if previously registered), or
it will prompt you to ENTER BASE ID to register the new Handset. See
Registration and Operation for details.
8
Follow the steps below:
Remove the battery cover by
pressing on the indent and
sliding downward.
Place the new battery pack in
the handset with the metal
contacts aligned with the charge
contacts
in
the
battery
compartment.
Replace the battery cover by
sliding it upwards.
If the new battery pack is not
already charged, place the
handset in the base unit, or a
remote charging stand, and
allow it to charge for 12 hours.
After
initial
charge,
a
maintenance charge of 8 hours
should be sufficient.
The Handset of your GIGAPHONE cordless telephone is powered by a
rechargeable battery pack. It charges automatically whenever the Handset is
in the Base Unit.
You should charge the battery pack for 12 hours when you first receive your
phone. You'll know the battery pack needs charging when:
•
The low battery message is
displayed :
•
The handset seems completely
dead, the LCD is completely
clear and does not activate
when you press the keys.
Do not dispose of a battery pack in a fire, the cell may explode.
Do not open or mutilate the battery pack. Toxic substances may be
released, causing harm to eyes or skin.
Exercise care in handling battery packs in order to prevent an accidental
short of the charge contacts, potentially causing the battery pack to
overheat.
Do not dispose of this battery pack into household garbage. Contact your
local recycling organization for recommended disposal sites.
9
Advertisement
Table of Contents
