Table of Contents
Advertisement
4.2. Manual Activation
1. Press the "signal key" or "level key" once to activate the device.
2. After activating the device, the screen lights up and displays the last displayed result.
3. After the device is activated, if there is no operation within 40 seconds, the screen will turn off and enter sleep mode.
4. If it is activated again within 40s after the previous activation, the device starts to update the signal value in real time.
Note: (1) R716S could show "noNe" due to the poor connection of network, interruption of signal, or long-distance
communication. It would start detection only when the network connection is stable. Pressing the signal key or the
level key would not activate the device.
(2) R716S would refresh the data every 5 seconds during the first 30 seconds. For the last 10 seconds, the final detection
result would be shown on the LCD screen.
4.3. Function Key
1. Detect Signal Strength:
Press the signal key, the LCD will display the current detected signal strength and update the signal value in real time.
2. Display Signal Level:
Press the level key, the LCD will display the current signal level based on the packet loss.
4.4. LCD Interface
R716S display four digits.
1. Press the signal key, and it will display the signal strength in four digits.
2. Press the level key, and it will display the signal level in the fourth digit.
The Range of Signal Strength Level:
Packet Loss (%)
Signal Level
Note: To get an accurate result, user should wait until the final detection result to show on the LCD.
90–100
80–90
70–80
0
1
2
60–70
50–60
40–50
3
4
5
5
30–40
20–30
10–20
6
7
8
0–10
9
Advertisement
Table of Contents
