Web Password Change; Indicator Display - Sony VPL-FH30 Service Manual

1-7. Web Password Change

If you forget your Web password, enter the Service mode (Section 1-6), and then set a new password in
[Password] in [Setup] in the Web screen.

1-8. Indicator Display

In this unit, the error status is indicated by the blinking of the indicator. There are ON/STANDBY indica-
tor and LAMP/COVER indicator on the top cover. The error differs depending on which indicator blinks.
For details of the blinking state of indicator and the error, refer to the list below.
ON/STANDBY indicator (Blinks in red)
Error
Temperature error
ON
OFF
Fan error
ON
OFF
Power error
ON
OFF
System error-1
ON
OFF
System error-2
ON
OFF
System error-3
ON
OFF
System error-4
ON
OFF
Assembly error
ON
OFF
LAMP/COVER indicator (Blinks in red)
Error
Cover error
ON
OFF
Lamp error
ON
OFF
1-40 (E)
Number of Status
blinking
2 The temperature inside of the unit exceeds
the tolerable range.
4 Any of fan does not operate normally.
6 The power is not output normally.
10 The data cannot be normally acquired from
the storage device (EEPROM) when the
power of sub-CPU is turned on.
11 The data cannot be normally acquired from
the storage device (EEPROM) when the
power of main-CPU is turned on.
12 The main-CPU does not operate normally.
13 The main-CPU does not operate normally.
14 The connector of temperature sensor is
disconnected.
Number of Status
blinking
2 The lamp cover or fi lter holder is removed.
The connectors to temperature sensor
boards (U and V boards) are not connected
properly.
3 The lamp does not light normally.
VPL-FH30