Sennheiser E 945 - Vocal Microphone Manual

Delivery includes

• e 945
• MZQ 800 microphone clamp
• pouch
• quick guide
• safety guide

Product overview

1. Sound inlet basket
2. XLR-3 connector

Installation

Attaching the device

• Screw the microphone clamp to a stand.
  
• Place the microphone with its back end into the microphone clamp.
  
• Orient the microphone together with the microphone clamp.

Connecting the device

• Connect the XLR-3 socket of the microphone cable (optional accessories) to the XLR-3 socket of the microphone.
  

Using the windshield

• Place the MZW 4032 (optional accessories) windshield over the microphone head.
  

Operation

Holding the device

If you cover the microphone head during transmission, this will change the pick-up pattern of the microphone and consequently the sound.

• Only hold the microphone by its body.
  

Positioning the unit

• It is vital to observe the following notes:

Pos.	Resulting sound	Commentary
	High proximity effect (large bass boost) Powerful, direct sound	Very little crosstalk from other sound sources
	Less proximity effect (less bass boost) Some room ambience, natural, balanced sound	More crosstalk from other sound sources
	Very little proximity effect (minimal bass boost) More room ambience, indirect sound	Higher crosstalk from other sound sources

If sibilance occurs:

• Position the microphone slightly to the side and not directly in front of the mouth.

Positioning the monitor loudspeakers

• To prevent feedback and crosstalk, postion your monitor loudspeakers in the angle area of the highest cancellation of the microphone (approx. 120°).
  

Cleaning and maintaining the product

LIQUIDS CAN DAMAGE THE ELECTRONICS OF THE PRODUCT!
Liquids entering the housing of the product can cause a short-circuit and damage the electronics.

• Keep all liquids away from the product.
• Do not use any solvents or cleansing agents.

• Disconnect the products from the power supply system and remove rechargeable batteries and batteries before you begin cleaning.
• Clean all products only with a soft, dry cloth.

Cleaning the sound inlet basket of the microphone module

• Unscrew the sound inlet basket.
  
• Remove the foam insert from the sound inlet basket.
  
• Use a slightly damp cloth to clean the sound inlet basket from the inside and ouside.
  
• If necessary, clean the foam insert with a mild detergent or replace the foam insert.
  
• Dry the foam insert.
  
• Reinsert the foam insert.
  
• Replace the sound inlet basket on the microphone head and screw it tight.
  

Specifications

Polar pattern

Frequency response

Connector assignment

Overview of applications

Primary application
Secondary application

Documents / Resources

Download manual

Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.

Download Sennheiser E 945 - Vocal Microphone Manual