Sennheiser a world-leading company in this field. Please take a few moments to read these instructions carefully, as we want you to enjoy your new Sennheiser products quickly and to the fullest.
“Safety information”, • using the microphone within the operating conditions and limitations described in this instruction manual. • using the microphone with care and storing it in a clean, dust- free environment. • not exposing the microphone to extreme temperatures. •...
965 microphone 965 is a fully professional true condenser vocal microphone utilising the very best in condenser microphone technology to achieve new standards of quality and sound. An extended dynamic range and a super-smooth frequency response deliver an outstanding signal quality with excellent vocal projection and the lowest possible distortion.
Connecting the microphone Use a microphone cable with XLR-3 female connector to connect the microphone’s XLR-3 male connector microphone preamplifier. The microphone preamplifier must provide 48 V phantom powering. Pin assignment of the XLR-3 connector symmetrisch to the 6,3 mm...
Using the microphone CAUTION! Danger of damage to the microphone! The switches on the microphone can be damaged if you try to operate them using tools. Only using your fingers. Unscrewing the sound inlet basket Unscrew the sound inlet basket in order to have access to the following moisture-protected switches: •...
Use the directivity switch to select the desired setting: : cardioid : super-cardioid Notes: In order to prevent feedback and crosstalk, postion your monitor loudspeakers in the angle area of the highest cancellation of the microphone (cardioid: 180°; super-cardioid: 135°). »...
Cardioid Adjusting the sensitivity When very high signal levels cause distortion in the microphone or in the subsequent microphone preamplifier, you can reduce the microphone sensitivity. The sensitivity can be reduced by 10 dB. Use the sensitivity switch...
Switching the low-cut filter on/off In order to effectively reduce low-frequency pop or wind noise, you can switch in the low-cut filter (bass roll-off). Use the low-cut filter switch to select the desired setting: : low-cut filter off : low-cut filter on...
• • • • • • If sibilance or “popping” occurs, position the microphone slightly to the side and not directly in front of the mouth. High proximity effect (large bass boost) Powerful, direct sound Less proximity effect (less bass boost)
Use a soft, slightly damp cloth to clean the microphone. Do not use any solvents or cleansing agents. To clean the microphone’s sound inlet basket from time to time, proceed as follows: Unscrew the sound inlet basket from the microphone (see “Unscrewing the sound inlet basket”...
Manufacturer Declarations Warranty 2 years CE Declaration of Conformity Sennheiser electronic GmbH & Co. KG declare that this device is in compliance with the applicable CE standards and regulations. Before putting the device into operation, please observe the respective countryspecific regulations!