Installation
Telephone base installation
It is recommended to install the telephone base away from any electronic equipment and appliances
• Use only the
such as personal computers, computer routers, television sets, microwave ovens, and refrigerators.
VTech battery
Avoid excessive heat, cold, dust or moisture. When a location is selected, install the telephone base
and AC power
and the charger as shown below.
adapter supplied
•
with this
telephone.
•
• This power unit
is intended to be
correctly oriented
in a vertical
Your telephone base comes with the bracket installed ready for desktop use. If you prefer to mount
or floor mount
your telephone on the wall, plug in the telephone line cord and the power adapter to the telephone base
position. The
as instructed above before changing it to a wall mount position (see page 7 for bracket installation).
prongs are not
designed to hold
the plug in place
if it is plugged
into a ceiling or
an under the
table/cabinet
outlet.
2
Plug the connector into the power jack at the bottom of the telephone base and chargers. Route cords
through slots and plug the power adapter into an electrical outlet not controlled by a wall switch.
Plug one end of the telephone line cord into the telephone line jack at the bottom of the telephone
base. Route the telephone line cord through slot, then plug the other end of the cord into the modular
wall telephone outlet.
Plug the telephone
line cord into a
telephone jack.
www.vtechphones.com
Plug power adapter into an
electrical outlet not controlled by
a wall switch.