Table of Contents
Advertisement
O P E R A T I N G
Press 1, 2 3, or 4 on the Handset to select
a ringer type. The Handset will emit the cor-
responding ringer tone.
Press OFF on the Handset to exit pro-
gramming.
TURNING OFF THE HANDSET RINGER
The Handset must
be OFF
Press PRG/PRV on
the Handset
Press # or * key on
the Handset
Press 5 to turn off
the ringer
Press OFF key to
exit
21
22
BASE RINGER CONTROL
This control switch is located on the right
hand edge of Base Unit.
Select HIGH, LOW or OFF setting.
CHECKING THE HANDSET RINGER
To check the ringer type which is currently
programmed, do the following:
Handset must be OFF
Press PRG/PRV on the Handset
Press # key on the Handset
Press 0 on the Handset. The phone will
ring once to show ringer selected.
Press OFF key to exit
918manual.pm6
I N S T R U C T I O N S
MEMORY DIALING
The 918` ADX cordless phone can store
up to10 frequently dialed numbers in memory.
Memory Dial numbers must be stored us-
ing the Handset, but can be recalled from ei-
ther the Base Unit or the Handset.
TO STORE A NUMBER INTO MEMORY
The Handset must be OFF
Press PRG/PRV on the Handset
TO PROGRAM
THE RING TYPE
MEMORY DIALING
900MHz
CORDLESS
INT.COM LOW BATT/MUTE
PHONE
*
PWR
IN
IN
USE
USE
CHR
py tone will be generated.
If programming was unsuccessful, a sad
tone is generated.
If the phone is left unattended in program
mode for longer than 30 seconds, it will gen-
erate a sad tone and automatically exit pro-
gram mode.
Write down the name and/or the phone num-
ber you assigned to each Memory Location
key on the directory card in the Base Unit
cradle.
TO DIAL A NUMBER FROM MEMORY
You can Memory Dial from either the
Handset or the Base Unit .
21
Press the Memory
Location key where
the phone number will
be stored (0-9)
Dial the number
you want to store. The
number can be up to
16 digits long
Press MEM on the
Handset to complete
programming
If programming has
been successful,a hap-
3/6/98, 3:21 PM
21
Advertisement
Table of Contents
