Installing The Loop Handle - Makita DUR193SF Instruction Manual

ASSEMBLY
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before carrying out any work on the tool.
CAUTION:
Never start the tool unless it is
completely assembled. Operation of the tool in a
partially assembled state may result in serious per-
sonal injury from accidental start-up.

Installing the loop handle

Attach the loop handle to the tool by securing it with a
hex bolt and the thumb nut as shown in the figure.
1
2
Fig.5
► 1 . Loop handle 2. Thumb nut 3. Hex bolt
The angle of loop handle is adjustable. To adjust the
angle of loop handle, loosen the thumb nut, then set the
loop handle at a proper angle according to your work,
and then tighten the thumb nut firmly.
Installing the protector
CAUTION:
While installing the protector, be
careful not to contact the nylon cord cutter on
the protector. Contact with the cutter could result in
personal injury.
1
Fig.6
► 1 . Protector 2. Nylon cord cutter 3. Screw
Mount the protector by fitting it on to the motor housing,
and then secure it with the screw.
2 3
Installing the wire guard
NOTICE:
too much. Otherwise it may break.
Fig.7
To reduce the risk of damaging the objects in front of the
cutting head, attach the wire guard to the motor housing
so that it controls the cutting range.
Slightly expand the wire guard outward and then insert
it into the holes of the motor housing.
3
Fig.8
► 1 . Wire guard 2. Hole
When wire guard is not in use, lift it for the idle position.
Fig.9
► 1 . Wire guard
9 ENGLISH
Do not expand the wire guard outward
1 2
1