Axis C1111-E User Manual page 36

AXIS C1111-E Cabinet Speaker
The web interface
Use access list: Turn on to restrict who can make calls to the device.
Policy:
• Allow: Select to allow incoming calls only from the sources in the access list.
• Block: Select to block incoming calls from the sources in the access list.
Add source: Click to create a new entry in the access list.
SIP source: Type the caller ID or SIP server address of the source.
Multicast controller
User multicast controller: Turn on to activate multicast controller.
Audio codec: Select an audio codec.
Source: Add a new multicast controller source.
• Label: Enter the name of a label that is not already used by a source.
• Source: Enter a source.
• Port: Enter a port.
• Priority: Select a priority.
• Profile: Select a profile.
• SRTP key: Enter an SRTP key.
The context menu contains:
Edit: Edit the multicast controller source.
Delete: Delete the multicast controller source.
Storage
Network storage
Ignore: Turn on to ignore network storage.
Add network storage: Click to add a network share where you can save recordings.
• Address: Enter the IP address or host name of the host server, typically a NAS (network-attached storage). We
recommend you to configure the host to use a fixed IP address (not DHCP since a dynamic IP address can change) or
that you use DNS. Windows SMB/CIFS names are not supported.
• Network share: Enter the name of the shared location on the host server. Several Axis devices can use the same
network share since each device gets its own folder.
• User: If the server requires a login, enter the username. To log in to a specific domain server, type
DOMAIN\username.
• Password: If the server requires a login, enter the password.
• SMB version: Select the SMB storage protocol version to connect to the NAS. If you select Auto, the device tries
to negotiate one of the secure versions SMB: 3.02, 3.0, or 2.1. Select 1.0 or 2.0 to connect to older NAS that don't
support higher versions. You can read more about SMB support in Axis devices here.
• Add share without testing: Select to add the network share even if an error is discovered during the connection test.
The error can be, for example, that you didn't enter a password even though the server requires one.
Remove network storage: Click to unmount, unbind, and remove the connection to the network share. This removes all settings
for the network share.
Unbind: Click to unbind and disconnect the network share.
Bind: Click to bind and connect the network share.
36